Quantum 1200 Series DAT Autochanger Guide de l'utilisateur télécharger pdf (Page 96)

LOG SENSE Command (4Dh) SDLT 600 SCSI Interface Guide

4-54 January 2005 81-81200-02 REV A01

Figure 4-28. TapeAlert LOG SENSE Page — Parameters Format

Bit

Byte

7 6 5 4 3 2 1 0

0 – 1

(MSB)

Parameter Code

(LSB)

DU DS TSD ETC TMC LBIN LP

3 Parameter Length (1)

4 Value of TapeAlert Flag (Flag is set when bit 0 is set to 1; bits 1–7 are reserved)

1. The byte 2 fields are collectively referred to as the Parameter Control Byte.

Table 4-32. TapeAlert Page LOG SENSE Parameters — Field Descriptions

Field Name Description

Parameter Code Contains the Flag code. See Table 4-33 on page 4-55 for the

supported flags, level of severity, and the flag definitions.

Parameter Length Always set to 1.

Value of TapeAlert Flag If bit 0 is set to 1, indicates that TapeAlert has sensed a problem. See

Table 4-33 on page 4-55 for the supported flags and their definitions.

If bit 0 is set to 0, indicates that TapeAlert did not sense a problem

and therefore did not set the flag.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 293 294

Pas de commentaire

Quantum 1200 Series DAT Autochanger Guide de l'utilisateur Page 96