Quantum QTM300CA Manuel d'utilisateur

QTM300CA USER'S GUIDE Cloning Adapter for the QT3xx family of QProx™ ICsThe QTM300CA is a cloningadapter designed to interfacebetween any QT3xx

Figure 5 - QT320 Clone ConnectionsVSS8S2AS1A263CS2BS1B5CSCKOUT27OUT2S2OUT14OUT11VDDVddS1SDOSDIGNDElectrode 2Electrode 1lq10QTM300CA/R1.02 25.09.03

Table 1 - Clone Cable Functional Pinout - Usage by PartN/CN/CN/C10SCKSCKSCK9Vcc1Vcc1Vcc18SDISDISDI / REQ7SDOSDOSDO6N/CN/CN/C5N/CN/CN/C4N/CN/CDRDY3GNDG

lQ Copyright © 2003 QRG Ltd. All rights reserved.Patented and patents pendingCorporate Headquarters1 Mitchell PointEnsign Way, Hamble SO31 4RFGreat

To begin using the board right away1. Connect the QTM300CA to a PC using the serial cable (included). Make sure theserial port is not being used by an

Figure 1 - Board LayoutIf a QT3xx chip has been auto-detected, this button will clone Setups data from theQTM300CA to the chip. The ‘PROG’ LED (see n

Indicates the programming status of the target chip in Stand-alone mode.The PROG LED will light during the cloning process in Stand-alone mode.Afterwa

Figure 2 - QT3View ScreenRestores a config file saved by (File | Save). All three part selector configurations (tabs)will be restored by this action.

The status bar at the bottom shows the serial port and connection status.Possibilities are:Serial Port Status: - Off Line- COM1: 57600 N 8 1- COM2: 57

Cloning Directly to a ChipYou can read and clone back information to a QT3xx chip directly from your PC without involving the onboardstand-alone memor

Clone the Setups to the Chip:Push the PROG button on the board.The PROG LED will light to indicate programming status.The PROG LED will flash to in

If the Synchronization input is used, a 10K resistor should be used to avoid problemswith the cloning process; see Figure 4 below.QT310Place the conn