Quantum 200D/400D Guide de l'utilisateur télécharger pdf (Page 56)

44 Troubleshooting and Diagnostics

The drive unloads, ejects the cartridge, exits Maintenance Mode, and the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, flashing

Single-character display

5, flashing

LCD

Ultrium Tape Drive

Drive Empty

To resolve the error, refer to Table 4-2 Error Codes, elsewhere in this chapter.

To clear the error, cycle (remove, then reapply) power to the LTO standalone.

Test Head

Use these tests to ensure that the drive head and tape-carriage mechanics are working correctly.

To select the Test Head function, perform the following steps:

1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.

2. Press the Unload button once per second until the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

LCD

Maint Mode : Select

Test Head

3. Press and hold the Unload button for two seconds to select Test Head.

The front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

c, flashing

LCD

Test Head

Load Scratch Tape

Within 60 seconds, insert a scratch data cartridge (or the drive will exit Maintenance Mode).

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 64 65

Pas de commentaire

Quantum 200D/400D Guide de l'utilisateur Page 56