Quantum Scalar 24 Guide d'installation télécharger pdf (Page 4)

4 62-2304-01 Rev A

Scalar 24

You must set the IP Address in the Scalar 24 before you can start the RMU. Follow the procedure

below to configure your RMU. Alternatively, you can also configure the RMU through the Setup

Wizard.

NOTE: For more information, refer to the Scalar 24 Installation and Operation Guide.

Path:

Setting the IP Address

Selection Description/Result

Step 1 From the Setup menu, highlight

and press .

Configures the RMU.

An error will appear if an RMU is not installed

or is not functioning properly.

Step 2 Set the IP Address by pressing

and to change the value of the

current field and and to move

between fields.

The current field will be highlighted. Make

sure you enter a valid number for each field.

Main Menu

Setup Menu

User Interface

1 2 3 4 5 6

Pas de commentaire

Quantum Scalar 24 Guide d'installation Page 4