Quantum DX30 Guide de l'utilisateur télécharger pdf (Page 60)

Chapter 3 DX-Series Remote Management

Configuration

42 Quantum DX-Series User’s Guide

3 Enter the alpha characters (0 to 6 characters) in the New Alpha Prefix

field.

4 Enter the numeric character in the Numeric Ending field.

5 When you have selected the tape(s) and both the alpha and numeric

characters, click

Apply.

Barcode labels are assigned for the selected tape(s).

Properties 3

The library name identifies the DX-Series system so it can be

distinguished from other devices on the network through the SNMP

interface.

To set the library name:

1 From the Library link of the Configuration page, click the Properties

link.

The Properties page displays (see figure 23).

Note: If you are entering alpha characters for the first part of a

barcode number and this is the first number in a range, no

more than five characters can be used. This allows the

system to assign the last character in the field.

Note: This number is used as the first number in the range of

tape cartridges. The number will increment with each

additional cartridge in the field.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 157 158

Pas de commentaire

Quantum DX30 Guide de l'utilisateur Page 60