Quantum FC420 Guide de l'utilisateur télécharger pdf (Page 12)

Quantum ATL M2500 Library User’s Guide Addendum—Prism FC420 Bridge Option

Document 6473031-01, Ver. 1, Rel. 1

August 2002

12 Configuring FC420 Firmware

Creating a Map File for

the FC420

Each FC420 Fibre bridge in the library requires a map file to identify

the SCSI devices in the library electronically connected to each Fibre

Channel port on the board.

To create the FC420 Prism Map, perform the following steps:

1 At the Ready prompt, type scsiportlist and then press <Enter>.

This command returns a list of available SCSI ports and their

current status. Valid status values are

OK and Failed.

2 If there are no SCSI bus failures, type automap and press <Enter>.

The automap command executes.

3 When the Ready prompt reappears, type saveconfiguration and

press

<Enter>.

4 When the Ready prompt reappears, type firmwarerestart and press

<Enter>.

Making Other

Configuration

Changes

The preceding firmware configuration steps are mandatory to ensure

the successful operation of the library. After completing these

procedures, you may want to make other configuration changes by

issuing other service commands.

Service Command List 0

For your convenience, the entire set of service commands for the

FC420 Fibre bridge are listed in the section that follows.

Using the Help Command 0

You can also obtain a list of service commands by typing

help and then

pressing

<Enter>.

To get more information about a particular command, type

help

command_name

and then press <Enter>. The variable command_name

is the exact name of the command you want information about.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Pas de commentaire

Quantum FC420 Guide de l'utilisateur Page 12