Quantum LTO-6 Guide de l'utilisateur télécharger pdf (Page 14)

3. Connect the SAS and power cords to the tape drive and plug the other end of the power cord into

the power outlet.

3. Power on/off switch1. SAS connector

2. Power connector

Figure 9 Connecting the cables to the tape drive

Reboot the server

Switch on the tape drive and power up the server. The power on/off switch is on the front panel.

Watch the boot screen carefully after installation. If there are any error or unexpected messages go

back and check the SAS cabling carefully.

If this does not resolve the problem, refer to Troubleshooting (page 27) for further guidelines.

14 Installing an external LTO Ultrium tape drive

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Pas de commentaire

Quantum LTO-6 Guide de l'utilisateur Page 14