Quantum DLT 7 Manuel Page 85

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 177
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 84
Chapter 9 Installing an Internal SCSI Tape Drive
Equipment Required
DLT-S4 Product Manual 67
Equipment Required 9
You need the following items to install the tape drive in a system:
Four (4) M3 x 8 mm long screws
Screwdriver
Jumpers (supplied)
Internal Ultra320 SCSI cable, SPI-4 (or SPI-5) compatible
Active Ultra320 SCSI terminator (if the SCSI cable is already
terminated at the end then you do not need this item)
Installation Steps 9
To install the tape drive, perform the following tasks in this order. Each
task is described in detail on the pages listed below.
Step No. Step Page
1
Unpack the tape drive. Page 69
2
Set the SCSI ID. Page 69
3
Secure the tape drive in the system. Page 71
4
Connect the cables and terminate the
SCSI bus.
Page 74
5
Set TERMPWR. Page 77
6
Confirm the installation. Page 78
7
Add an additional device (optional). Page 78
Vue de la page 84
1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 176 177

Commentaires sur ces manuels

Pas de commentaire