Quantum Scalar i6000 Guide de l'utilisateur télécharger pdf (Page 75)

Chapter 3: System Specifications

Physical Specifications – Library

Scalar i6000 Planning Guide 69

• Optional 72-slot can be installed in DREMs, HDEMs or SEMs, but not

in the RPM.

• The LPM cannot support I/E Stations.

• A maximum of 16 I/E stations (including the CM I/E Station) can be

installed in a library, but with the restrictions listed above.

• I/E Stations are installed left to right, with the 72-slot I/E Stations

installed closest to the CM followed by 24-slot I/E Stations.

Tape Drive Support and Placement

• The library supports a maximum of 192 tape drives.

• Tape drives are only installed in CMs and DREMs.

• SEMs, HDEMs and the LPM do not support tape drives, but SEMs

can be converted to DREMs for drive support. Note that DREMs can

only be used as a RPM in a Dual Robot library if they do not have the

full compliment of 24 drives.

• A maximum of 18 drives can be installed in each control module

and a DREM can contain a maximum of 24 drives.

• While drives can be installed in any module configured to accept

them, it is recommended that they are installed left to right, with

the first drives installed in the CM and moving to the next DREM to

the right.

Power cords

• The default power cords are sent with each CM, DREM and HDEM. If

redundant power is ordered, an extra cord is sent. If any of the

optional power cords are needed, they must be ordered.

Basic Building Blocks Tab le 10 provides specifications for the common building blocks to help

you calculate your specific configuration.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 105 106

Pas de commentaire

Quantum Scalar i6000 Guide de l'utilisateur Page 75