Quantum DAT 160 Guide de l'utilisateur télécharger pdf (Page 27)

Chapter 2 Installing Internal Tape Drives

Install Drive

Quantum DAT 160 User’s Guide 13

1 Use a Torx screwdriver to attach the appropriate screws. You may

need to purchase the M3 screws separately. Position the screws (see

figure 5

Figure 5 Attaching Mounting

Screws

2 Attach the appropriate mounting hardware. Refer to the

manufacturer’s documentation for instructions.

• If you are installing on a server that requires a tray, place the tape

drive in the tray.

• If you are installing in a server that requires mounting rails,

fasten the rails to the tape drive.

• Some servers have snap-on mounting rails attached to the filler

panel. These can be removed and attached to the tape drive with

screws.

Install Drive

Slide the tape drive into the open bay aligning the tray or rails with the

slots in the bay (see figure 6

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 81 82

Pas de commentaire

Quantum DAT 160 Guide de l'utilisateur Page 27