Quantum Scalar 100 Guide de l'utilisateur télécharger pdf (Page 20)

16 Installation

Installing the SNC 6101 in a Scalar 100

To install the SNC 6101

1 Power down your Scalar 100 and disconnect the AC power cord from the voltage source.

2 At the rear of the Scalar 100, find the bottom, left filler plate (see Figure 4

3 Remove the filler plate by unscrewing the two thumb screws identified in Figure 4

4 Position the SNC 6101 module as shown in Figure 5

on page 17. Make certain the two RJ-45 and null

modem ports are positioned at the top.

5 Align the top and bottom rails of the SNC 6101 with those on the Scalar 100 and slide the module into

the chassis until it is flush.

Figure 4 Scalar 100 Filler Plate Removal

CAUTION

Save this filler plates for future use. If the SNC 6101 is removed, the

empty slot must always be covered to prevent debris from entering

the equipment and to enable proper air circulation for cooling.

Note

The mounting rails prevent the SNC 6101 from being inserted wrong side

up.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Pas de commentaire

Quantum Scalar 100 Guide de l'utilisateur Page 20