Quantum TC2201E Guide de l'utilisateur télécharger pdf (Page 45)

Chapter 2 Getting Started

Configuring the TC2201E

Quantum TC2201E User’s Guide 25

to 90 seconds, during which time the POST and initialization

information may or may not be visible on the terminal or terminal

emulator.

The baud rate used by the terminal or terminal emulator must be

9600, 19200, 38400, 57600, or 115200. The TC2201E will not function

properly at any other baud rate.

Once the POST and firmware initiation processes are complete, the

main menu should be accessible over the serial port. Optionally, the

main menu can also be accessed over the Ethernet port as described

in the next Chapter of this manual.

Figure 20 TC2201E

Power Switch and

Connector

Reset Button

Power

switch

Power

connector

Configuring the TC2201E 2

The TC2201E can be configured in a variety of ways. The following are

general procedures for setting up basic operation. Not all of these settings

will apply to every environment, but these guidelines should provide the

fundamental steps for configuring the TC2201E.

Configuring the

TC2201E using the

Visual Manager

To configure the TC2201E using the visual manager:

1 While DHCP support is enabled by default on the TC2201E, it is

important to ensure that the Ethernet setting for DHCP is set to

Enabled or that a valid IP address and IP gateway have been properly

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 201 202

Pas de commentaire

Quantum TC2201E Guide de l'utilisateur Page 45