Quantum TC2201E Guide de l'utilisateur télécharger pdf (Page 52)

Chapter 3 Quantum Visual Manager

Accessing Visual Manager

32 Quantum TC2201E User’s Guide

Accessing Visual Manager 3

1 Connect a 10baseT or 100baseT Ethernet cable to the TC2201E.

2 Apply power to any connected SCSI or iSCSI devices.

3 After all attached devices have gone through their power up routines,

boot up the TC2201E.

4 Turn on the host computer.

5 If the IP address for the TC2201E is known, open the computer’s Web

browser and enter the IP address into the Address field. The factory

default of the TC2201E has DHCP enabled. To disable DHCP, refer to

appendix C, Using the Command Line Interface for information on

disabling the DHCP option.

If you do not know the IP address of the TC2201E, then connect to the

TC2201E using the serial (RS-232) connection (a 3-pin serial cable is

included with the TC2201E). Current settings can be viewed and

changed from the Ethernet Configuration Menu of the serial

interface.

Note: For manual IP address configuration, the TC2201E has a

default fixed IP address of 1.1.1.1 but this is technically not a

valid IP address. For remote access from WAN or Internet

locations, the IP address must be changed to a valid IP

address. Valid IP addresses have the form x.x.x.x where each x

is an integer in the range of 0 to 255.

Note: To access the QVM user interface, the TC2201E must be

assigned an IP address.

Note: If the TC2201E is to use a static IP address, the default IP

address 1.1.1.1 should be changed to an address that is

appropriate for the IP network it will reside on. Note that the

default IP address can be used in a direct connection between

the TC2201E and the host computer via a crossover Ethernet

cable.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 201 202

Pas de commentaire

Quantum TC2201E Guide de l'utilisateur Page 52