Quantum DAT72 Guide de l'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 81
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Chapter 2 Installing Internal Tape Drives
Parity Checking
DDS-4/DAT 72 User’s Guide 17
Parity Checking 2
Jumper Pins 9–10:
Pins 9-10 shunted: Enable parity checking (default)
Pins 9-10 open: Disable parity checking
By default, parity checking is enabled on the internal tape drive. To
disable parity checking, remove the jumper from pins 9 and 10.
13 Shunted Open Shunted Shunted
14 Open Shunted Shunted Shunted
15 Shunted Shunted Shunted Shunted
Note 1 = This ID is assigned to the HBA and should not be selected for the drive ID
Note: You can also change SCSI IDs by connecting a SCSI address-
selection switch to pins 1 through 8.
If you change the drive’s default SCSI ID, avoid using SCSI
IDs 0 and 1 (which typically are assigned to a boot drive) and
SCSI ID 7 (which typically is assigned to SCSI controllers or
host bus adapters).
Note: If you disable parity checking, the drive still generates a parity
bit.
Jumpers
SCSI ID 1-2 3-4 5-6 7-8
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 80 81

Commentaires sur ces manuels

Pas de commentaire