Quantum DX30 Guide de l'utilisateur télécharger pdf (Page 32)

Chapter 2 OpenView NNM on Windows NT/2000

Setting Up OpenView NNM

18 SNMP Integration Guide

To create duplicate IP addresses:

1 Determine the IP address of the PMC Ethernet port.

If the IP address of the PMC Ethernet port attached to the network

begins with anything other than the number 10, the IP address of the

second port is 10.0.0.254. Otherwise, the IP address of the second

Ethernet port is 192.168.0.254.

2 Create an ASCII file. Name and place it as follows:P

\HP Openview\NNM\conf\netmon.nodiscover

3 Add a line to the file containing only the IP address determined in

step 1

of this section.

For example, if the IP address of the second Ethernet port is

determined to be 10.0.0.254, then add the following line to the file:

10.0.0.254 #MC300 private network address.

Setting Up OpenView NNM 2

After the SNMP integration software is installed, set up OpenView NNM.

To set up OpenView NNM:

1 If OpenView NNM is running, shutdown, and restart OpenView

NNM. If OpenView NNM is not running, start OpenView NNM.

2 Navigate to the network where the library devices are located (see

figure 13

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 57 58

Pas de commentaire

Quantum DX30 Guide de l'utilisateur Page 32