Quantum Scalar 1000 Guide de l'utilisateur télécharger pdf (Page 40)

4-4 System Specifications

6-01150-01 Rev A

Electrical Specifications

The electrical specifications for the Control Module (CM) and

Expansion Module (EM) are shown in Table 4-3.

The typical power consumption for a full-height/half-height

drive and the SNC 5100 is shown in Table 4-4.

The EMs only need power if there are drive bays installed.

Table 4-3 Electrical Specifications

Module

Voltage

(Single Phase)

a. Connect an 18 gauge stranded copper wire from the CM to earth ground.

kVA

United States

Power Connector

International Power

Connector

CM/EM 115 - 230 1.6 L5 - 20 Plug is customer supplied

Table 4-4 Typical Component Power Consumption (Worst Case)

Component Status Watts BTU

Full-Height Drive Read/Write 71.5 244

Idle 53.0 180

Half-Height Drive

(Two in sled AIT)

Read/Write 53.8 263

Idle 24.6 120

SNC 5100 Read/Write 33 113

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Pas de commentaire

Quantum Scalar 1000 Guide de l'utilisateur Page 40