Quantum Scalar i6000 Guide de l'utilisateur télécharger pdf (Page 10)

Chapter 1 System, Safety, and Regulatory Information Guide (ENG)

Quantum Safety Information

System, Safety, and Regulatory Information Guide 6

Safety and Laser Devices 1

For those systems that contain a barcode reader, the barcode reader may

contain a laser device. Also, this product may be used with Small Form

factor Pluggable (SFP) transceivers or GigaBit Interface Converters

(GBIC), as indicated in the product documentation. The SFPs and GBICs

incorporate a Class 1 laser. This system complies with the applicable

requirements of 21 CFR 1040.10, IEC 60825, and EN 60825, when used

with a Class 1 laser product. The SFP (or GBIC) emits laser radiation, and

it must be used and installed as required by the vendor instructions for

the SFP (or GBIC). The optical ports of the optical transceiver modules

should be terminated with an optical connector or with a dust plug.

Safety and the Power

Connection 1

Be aware of the ampere limit on any power supply or extension cables

being used. The total ampere rating being pulled on a circuit by all

devices combined should not exceed 80% of the maximum limit for the

circuit.

Warning: Do not position any system or system component in such a

way that it could be used as a step.

Warning: Do not stare into a laser beam. Do not view it with optical

instruments. Avoid direct exposure to the laser beam.

Warning: Always use properly grounded, unmodified electrical

outlets and cables, capable of supplying the proper voltage

and current.

Warning: The power outlet must be available near the unit and must

be easily accessible.

Warning: Hold the AC power plug by the head when you pull it

from the AC source outlet. Pulling on the cord can damage

the internal wires.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 173 174

Pas de commentaire

Quantum Scalar i6000 Guide de l'utilisateur Page 10