Quantum Scalar 218 Spécifications télécharger pdf (Page 36)

26 Equipment Description

Notes

• With the factory default conditions unchanged, the library will

sign-on as a Scalar 218 as shown in the above illustration. If the

Off-Line mode Configuration Menu, Product Sign-On parameter

has been set to EXB-480:Y (see Off-Line Mode Menus,

Configuration Menu, Product Sign-On subsection of Chapter 4:

Equipment Description for further information about how the

library signs-on.

• The Scalar 218 displays the current internal temperature (in

degrees centigrade) of the library on the right-side of the top line of

the Operator Panel LCD. Whenever the internal temperature meets

or exceeds 40º C, an alarm will sound and a message will appear

on the LCD stating that the safe operating temperature has been

exceeded. Once the temperature falls below 40º C, the alarm will

quit and the message will be removed from the LCD.

You are now ready to install the backup software – if it has not already been installed.

Installing the Backup Software

At this point you need to refer to your software installation guide for instructions on installing

the backup/controlling software for the Scalar 218 onto the host computer.

Note

This is the software that runs your Scalar 218, not the data being

transferred to the data cartridges. Two examples of backup software are

Cheyenne's ARCserve and Legato's NetWorker.

After you have completed installation of the Scalar 218 and of the software, to make sure that

your unit is operating correctly, you should run any diagnostic test(s) supplied with the backup

software.

Once your Scalar 218 has been connected to your host computer system and the application

software has been installed, the library is ready for use. Just turn on the power switch.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 108 109

Pas de commentaire

Quantum Scalar 218 Spécifications Page 36