Quantum Scalar 50 Manuel d'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-02 A01
July 2008
Setting the Tape Drive SCSI ID 11
There are two ways to set the tape drive SCSI ID:
Setting the SCSI ID Using the OCP
Setting the SCSI ID from the Remote Management Pages
Setting the SCSI ID
Using the OCP
0
To set the tape drive SCSI ID on an Scalar 50 Series library with an LCD:
1 From the operator control panel (OCP), press
Setup from the Home
screen. The OCP displays the
Setup screen (see figure 10):
Figure 10 Setup Screen
2 Use the up and down arrows to highlight Cabinet and press Enter.
The
Cabinet screen displays (see figure 11):
Figure 11 Library Options
Screen
3 Use the up and down arrows to highlight Host bus and press Enter.
The
Host bus screen displays (see figure 12):
Note: SAS tape drives do not require a SCSI ID and cannot be
configured. Used the default tape drive configuration
information.
Note: Surrogate control is set via the
Partition page on the remote
management pages.
Enter
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire