Quantum Scalar 50 Manuel d'utilisateur télécharger pdf (Page 3)

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-02 A01

July 2008

Introduction 3

Introduction 0

This document provides instructions for adding a tape drive to an Scalar 50

tape library. The tape drive upgrade procedure consists of the following

steps:

• Unpacking the Tape Drive

• Installing the Tape Drives

• Cabling the Tape Drives

• Setting the Tape Drive SCSI ID

• Completing the Native Fibre Channel Installation

• Fibre Channel Connectivity Troubleshooting

Tape Drive Numbering 0 The Scalar 50 tape library may contain up to 4 tape drives depending on the

tape drive type. Refer to the following figures:

• Figure 1

Full height drives (up to two per library)

• Figure 2

Half-height drives (up to four per library)

Figure 1 Scalar 50 Cable

Configuration (Full Height

Drives)

Note: Half-height tape drive canisters are ONLY available in Scalar 50

tape libraries.

Back of Library

Tape drive 1Tape drive 2

1 2 3 4 5 6 7 8 ... 23 24

Pas de commentaire

Quantum Scalar 50 Manuel d'utilisateur Page 3