Quantum Scalar 50 Manuel d'utilisateur télécharger pdf (Page 12)

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-02 A01

July 2008

12 Setting the Tape Drive SCSI ID

Figure 12 Host Bus

Options Screen

4 Use the up and down arrows to highlight the tape drive receiving the new

SCSI ID and press

Enter.

5 Use the up and down arrows to select a SCSI ID and press

Enter to set the

ID.

6 When you have completed setting the SCSI IDs, press

Exit to return to the

Cabinet screen.

7 From the

Ops screen, use the up and down arrows to highlight Drive

Operations

and press Enter.

The

Drive Operations screen displays (see figure 13):

Figure 13 Drive

Operations Screen

8 Use the up and down arrows to select a tape drive and press Enter.

9 Use the up and down arrows to select

Off and press Enter.

The tape drive powers down and returns to the

Drive Operations screen.

10 Use the up and down arrows to select

On and press Enter.

The tape drive powers on and is ready for use. The tape drive installation

is complete.

Setting the SCSI ID

from the Remote

Management Pages

To set the tape drive SCSI ID on a Scalar 50 Series library from the remote

management pages:

1 On the host computer, open the internet browser software.

2 In the

Address field, type http://IPaddress/ where IP address is the IP

address for the Quantum Scalar 50 Series library.

Note: The library must be off-line during this procedure.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Quantum Scalar 50 Manuel d'utilisateur Page 12