Quantum LTO-2 Manuel d'utilisateur télécharger pdf (Page 27)

Chapter 2 Installation and Quick Start

Installing an Internal LTO-2 Half-Height Tape Drive

LTO-2 Half-Height Tape Drive User’s Guide 13

Connecting a SCSI

Cable

The internal LTO-2 Half-Height Tape Drive has an Ultra3 SCSI interface,

terminated by an LVD SCSI connector. Use the following procedure to

connect a SCSI cable to this connector.

1 Turn off all power to the drive and the computer.

2 Attach the SCSI interface cable to the 68-pin SCSI interface connector

on the back of the drive (see figure 5

Figure 5 Rear View of

the Internal LTO-2

Half-Height Tape Drive

Caution: Install an LVD drive only in an LVD environment.

Plugging an LVD drive into an HVD bus makes the entire

bus non-functional and may permanently damage the

drive or other SCSI devices on the bus.

SCSI Jumper Block

Pin 1

Library Interface Connector

SCSI Connector

Power Connector

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 93 94

Pas de commentaire

Quantum LTO-2 Manuel d'utilisateur Page 27