Quantum Tape Drive A-Series Manuel d'utilisateur télécharger pdf (Page 40)

Chapter 3 Using Your Tape Drive

Power On Self-Test (POST) Troubleshooting

Quantum A-Series Tape Drives User’s Guide 24

Figure 9 SDLT 600A Tape

Drive Front Panel LEDs

POST Troubleshooting

Tips 3

Table 6 provides troubleshooting tips that you will find useful in the

event that your tape drive fails its POST.

4 When POST is complete, the middle LED stops flashing

and remains illuminated; the left LED turns off, and right

LED remains off.

POST

Failure

If POST fails, the middle and right LEDs illuminate

steadily and the left LED flashes.

Note: If a data cartridge is in place when power is turned on, all

stages remain the same except Stage 3. It may take a

considerably longer time for Stage 3 to complete due to tape

rewind and searching operations that occur during that stage.

Stage What You Observe

Green/Orange LED

Green LED

Yellow L ED

(Cleaning Required)

(Cartridge Status)

(Drive Status)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 104 105

Pas de commentaire

Quantum Tape Drive A-Series Manuel d'utilisateur Page 40