Quantum Scalar i40 Guide de l'utilisateur télécharger pdf (Page 208)

Chapter 7: Encryption Key Management

Configuring Scalar Key Manager (SKM) on the Library

180 Quantum Scalar i40 and Scalar i80 User’s Guide

Step 2: Install the EKM

License Key on the

Library

If your EKM license key is not already installed on the library, install it

now (see

Adding or Upgrading Licensable Features on page 68).

Step 3: Prepare

Partitions for Library

Managed Encryption

For each partition on which you want to enable Library Managed

Encryption, do the following:

1 Make sure the partition contains encryption-supported and

encryption-capable tape drives and media. Note the following:

• SKM partitions must contain only LTO-4, LTO-5, and/or LTO-6

tape drives. SKM media must have valid barcode labels affixed.

SKM does not support the use of unlabeled media.

• KMIP partitions must contain only LTO-4, LTO-5, and/or LTO-6

tape drives.

2 Unload tape cartridges from all tape drives in the partitions on

which you are configuring EKM.

Step 4: Configure

Encryption Settings and

Key Server Addresses

Make sure to complete the above steps before proceeding.

Note: You cannot edit the encryption system configuration settings

when any partition is enabled for Library Managed Encryption.

If this happens, go to Setup > Encryption > Partition

Configuration, change all EKM partition settings from LME

enabled to LME disabled. Then make your changes to the

system configuration settings. Finally, go back and change all

the EKM partition settings to LME enabled.

1 From the Web client, select Setup > Encryption > System

Configuration (see

Figure 31).

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 339 340

Pas de commentaire

Quantum Scalar i40 Guide de l'utilisateur Page 208