Quantum Scalar i40 Guide de l'utilisateur télécharger pdf (Page 297)

Chapter 10: Troubleshooting

Performing Library Diagnostics

Quantum Scalar i40 and Scalar i80 User’s Guide 269

Web Client

1 Enter Diagnostics (Tools > Diagnostics, then click OK to take

partitions offline and log out all other users of the same or lower

privileges).

2 Select Drives > Drive Tests > Reset.

3 If the tape drives are assigned to more than one partition, select the

partition in which the tape drive(s) you want to reset are located.

Select Unassigned if the tape drive(s) you want to reset are not

assigned to a partition. Click Next.

4 Select the tape drive(s) you want to reset.

5 Click Apply.

6 The test runs. When complete, a “success” or “failure” message

displays.

Robotics Get/Put Test The Get/Put Test requires the robot to remove one tape cartridge from

the top I/E station slot, and then put the tape cartridge back into the

same slot. To run this test, you must insert a tape into the library’s top

(uppermost) I/E station slot.

You can only perform this test from the Web client, by entering

Diagnostics (see

Performing Library Diagnostics on page 267).

Web Client

1 Install a scratch tape in the top I/E station slot.

2 If manual cartridge assignment is enabled, assign the scratch tape

to the System partition.

3 Enter Diagnostics (Tools > Diagnostics, then click OK to take

partitions offline and log out all other users of the same or lower

privileges).

4 Select Robotics > Robotics Get/Put Test.

5 Click Apply.

6 The test runs. When complete, a “success” or “failure” message

displays.

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 339 340

Pas de commentaire

Quantum Scalar i40 Guide de l'utilisateur Page 297