Quantum Scalar i40 Guide de l'utilisateur télécharger pdf (Page 245)

Chapter 8: Getting Information About the Library

Viewing the Location of the Robot

Quantum Scalar i40 and Scalar i80 User’s Guide 217

• Encryption (this section displays only if encryption key management

is licensed and configured on the library) — Key server type;

encryption software version; SSL connection (enabled/disabled);

primary host (primary key server IP address or host name), primary

key server port number; primary key server serial number; secondary

host (secondary key server IP address or host name); secondary key

server port number; secondary key server serial number.

• Library Partitions — Name, serial number, control path, online/

offline status, encryption method, encryption type, number of

storage slots, number of media, and number of tape drives

configured for each partition.

• Drives — Location coordinates, vendor, model, type, serial number,

physical serial number (P-SN), logical serial number (L-SN), firmware

level, and encryption method.

Operator Panel

1 Select Reports > About Library.

2 Press Next to scroll through all the screens. Press Exit to exit at any

time.

Web Client

Select Reports > System Information.

Viewing the Location of the Robot

You can set the operator panel to view the robot position as library

operations are performed. This view is helpful in diagnosing any library

problems because you can see where the robot is, whether it contains a

tape, and the finger position.

If you perform an operation from the remote interface, the operator

panel displays the operation as it is performed. If you perform an

operation from the operator panel, once complete, you can return to

the Robot View to view the completed operation status.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 339 340

Pas de commentaire

Quantum Scalar i40 Guide de l'utilisateur Page 245