Quantum Scalar i40 Guide de l'utilisateur télécharger pdf (Page 42)

Chapter 2: Initial Installation and Setup

Unpacking the Library

16 Quantum Scalar i40 and Scalar i80 User’s Guide

Caution: Lift the library chassis at the sides. Avoid putting the

weight of the library chassis on the front bezel.

4 Remove the anti-static wrapping from the library. Keep the anti-

static wrapping intact so that you can use it later if needed.

5 Save

the packing box, packaging material, and anti-static wrapping

in case you need to move or ship the library in the future.

6 Remove the robot restraint. The

robot restraint consists of four (4)

thumbscrews, a mylar sheet, and a small metal clip, located on the

top cover of the library. See Figure

7 and Figure 8.

a P

artially unscrew (about 3 or 4 turns) all four thumbscrews, but

do not remove them.

b Usi

ng your fingers, carefully push down on two diagonally

positioned thumbscrews. Push them down as far as they will go.

This ensures that the robot can initialize freely. See Figure

Figure 7 Pushing Down on

Thumbscrews to Release Robot

Push down on two diagonally

positioned thumbscrews

c Completely unscrew and remove the four thumbscrews from

the top cover (see Figure

8). Save the thumbscrews in case you

need to move or ship the library in the future.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 327 328

Pas de commentaire

Quantum Scalar i40 Guide de l'utilisateur Page 42