Quantum DLT 4000 Manuel télécharger pdf (Page 42)

100

101

Hardware Implementation

2-8 Quantum DLT 4000 Tape Drive

Figure 2–4 Tabletop (Version 2) Back Panel Controls

SCSI ID - The SCSI ID default for the tabletop drive is set to 5; the drive can be

configured for SCSI ID addresses that range from 0 to 7 using the SCSI ID

pushbutton. Press the button above or below the ID number display to set the

desired SCSI ID. The top button increases the ID number; the bottom button

decreases the ID number.

TERMPWR and/or Parity Check - The tabletop version of the drive can be

internally configured to supply TERMPWR or parity checking. Contact your

service representative if you want to change either of these settings on the

tabletop version of the drive.

2.3 DRIVE INSTALLATION

This section describes how to mount and secure the drive in the system. Figure 2–

5 shows the mounting locations and dimensions for the drive.

Power Switch

Power Connector

SCSI Signal Connector

(Out/Termination)

SCSI ID Pushbutton

SCSI Signal

Connector (IN)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 299 300

Commentaires sur ces manuels

Pas de commentaire

Quantum DLT 4000 Manuel Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de bandes magnétiques Quantum DLT 4000