Quantum DLT 7000 Manuel télécharger pdf (Page 298)

100

101

Appendix D: The Tape Cartridge

D-6 Quantum DLT 7000 Tape Drive

6. Ensure that the tape leader within the tape cartridge is in the correct

position. To do this, you must open the tape cartridge door. Refer to Figure

D-3.

Figure D-3 Opening the Door on a DLTtape Cartridge Showing Tape Leader Loop in its

Correct Position

Open the door by holding the DLTtape cartridge as shown in Figure D-3.

On the right side corner of the tape cartridge there is a small tab in a cut-out

portion of the cartridge. Using your thumb, gently lift up on the tab and swing the

door open (Figure D-3).

Inside the door, you will see the tape and cartridge leader loop. The loop should

stick up about an eighth of an inch when viewed from the edge; the loop must be

a closed loop. If the loop is torn, bent, pulled in, or not sticking up about an eighth

of an inch, do not use the tape cartridge.

Leader

Loop

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 311 312

Commentaires sur ces manuels

Pas de commentaire

Quantum DLT 7000 Manuel Page 298

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de bandes magnétiques Quantum DLT 7000