Quantum DLT 8000 Manuel Page 69

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 408
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 68
Configuring, Installing, and Operating the Tape Drive
Quantum DLT 8000 Tape System 2-15
2.3 Configuring and Installing a Tabletop Tape System
This section provides instructions for configuring and installing the tabletop version of
the tape system. The tabletop version is enclosed in a top cover and the enclosure
includes a separate power supply. The power switch and the SCSI ID selection switch
are located on the unit’s rear panel. SCSI cables and the unit’s ac power cable are
connected at the rear panel.
WARNING
Before you begin, review the Safety, ESD, and Handling precautions described at
the beginning of this chapter to avoid personal injury or damage to equipment.
This section contains information about configuring (“tailoring”) the tape system via
the unit’s external switches. Settings are included for the following options:
Option See Section….
SCSI ID Selection 2.3.1
Connecting SCSI Cable(s) and/or Terminators 2.3.2
Connecting AC Power Cable 2.3.3
NOTE
To disable parity, contact your service representative. There are no external
switches on the tabletop version to disable parity checking.
Figure 2-7 provides physical dimensions of the tabletop unit.
Vue de la page 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 407 408

Commentaires sur ces manuels

Pas de commentaire