Quantum SuperLoader 3 Manuel d'utilisateur télécharger pdf (Page 6)

Quantum SuperLoader 3: Magazine or Magazine Blank Replacement

6-68059-01 Rev A

October 2013

6 Removing a Magazine or Magazine Blank

Note: Handles are either right or left. They are not interchangeable between

the left and right sides of the autoloader.

Removing a Magazine 1 On the menu, scroll to Commands.

2 Press Enter.

3 On the Commands sub-menu, scroll to Eject, and then press Enter.

4 On the Eject sub-menu, scroll to Right Magazine or Left Magazine,

depending on which magazine you want to eject, and then press Enter.

The magazine pops forward so that the front of the magazine is no longer

flush with the front panel.

5 With one hand, grasp the magazine by the handle and slide it forward to

remove. Place your other hand under the magazine to support it and

prevent it from falling.

6 Remove any tapes, one at a time, from the magazine. Rotate the gear

handle (Figure 5) on the back of the magazine to align the tape(s) with

either of the two openings (Figure 6 on page 7) along the top half of the

magazine, removing each tape individually.

Figure 5 Magazine Gear

Handle

gear handle

1 2 3 4 5 6 7 8

Pas de commentaire

Quantum SuperLoader 3 Manuel d'utilisateur Page 6