Quantum Scalar 50 LTO-3HH Guide de l'utilisateur télécharger pdf (Page 122)

Chapter 3 Quantum Scalar 50 Remote Management

Setup

Quantum Scalar 50 User’s Guide 98

SNMP 3

If the customer wishes to use the Quantum Scalar 50 system with a

network framework application such as HP OpenView, or CA Unicenter,

the SNMP configuration must be defined. SNMP stands for Simple

Network Management Protocol, a set of protocols for managing complex

networks. SNMP works by sending messages, called protocol data units

(PDUs), to different parts of a network. SNMP-compliant devices, called

agents, store data about themselves in Management Information Bases

(MIBs) and return this data to the SNMP requesters.

1 Under Community Names (see figure 67), click New to enter the new

community information:

a A unique name in the Name field, the field holds up to 60

characters. No blank spaces are allowed.

b IP address in the IP Address field, if the value in the Network

Mask edit box ends in a zero, the value in the IP address edit box

must also end in a zero

c Subnet mask in the Network Mask field.

d Access rights for the new community:

• Read Only allows SNMP read operations:

• Read/Write allows both SNMP read and write operations.

2 Click Save.

A Results page displays indicating the community has been added.

3 Click New in the Trap Destination area (see figure 67), to set the IP

addresses that are to receive the traps generated by the Quantum

Scalar 50,

for example, 12.34.56.78.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 289 290

Pas de commentaire

Quantum Scalar 50 LTO-3HH Guide de l'utilisateur Page 122