Quantum Scalar 100 Guide de l'utilisateur télécharger pdf (Page 36)

4-26 6-00667-01 Rev B

Scalar 100

To remove the standard Mailbox

1. Turn off the Scalar 100 library. (Both the front and the rear power switches.)

2. Open the library front door. Remove the tape cartridge(s) from the standard Mailbox.

3. Remove the three Mailbox cable clamps. Two of the cable clamps are attached to the door with

#2 Phillips screws and one is attached with a 11/32 nut. Disconnect the Mailbox cable harness

from the display assembly.

4. Remove the five 11/32 nuts that attach the Mailbox assembly to the front door. There are two

nuts on the left side and three on the right side.

5. Remove the 11/32 nut from the bottom of the plastic cover and loosen T20 torx screw under the

Mailbox door.

6. Remove the Standard Mailbox assembly.

7. Remove the plastic cover by lifting it up and sliding it through the front door.

Installing the Bulk Load Mailbox

Use Figure 4-2 on page 4-27 when installing the bulk load Mailbox.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 125 126

Pas de commentaire

Quantum Scalar 100 Guide de l'utilisateur Page 36