Quantum Scalar 10K Instructions d'exploitation télécharger pdf (Page 300)

6-26 Error Messages

6-00058-05 Rev A

7A 00 00 Failures detected in the Gripper Assembly Retract operations.

Action 1

Contact GCH. For GCH contact information, refer to Getting More Information

or Help on page 1-8.

7B 00 00 Failure detected in a Teach Master operation. This failure occurs most

likely when a Teach operation is executed as part of the Installation

process.

Action 1

Contact GCH. For GCH contact information, refer to Getting More Information

or Help on page 1-8.

7C 00 00 Failures detected in the Gripper Assembly Reach operation.

Action 1

Check for an object blocking operation in the cell. An obstruction can be any

of the following:

• an unlabeled cartridge

• a cartridge in the cell during a Put operation

• the DLT drive door is stuck during a Put operation

Remove the obstruction, then close the aisle door and retry the failing

operation.

Action 2

If the problem is not corrected or persists, contact GCH. For GCH contact

information, refer to Getting More Information or Help on page 1-8.

7E 00 00 Failure detected while pushing a cartridge into a tape drive feed slot.

Action 1

Check the cartridge for any physical damage, and verify that the cartridge

label is correct.

Action 2

Check the front of the drive sled to make sure no physical obstructions are

preventing the tape from being inserted.

Action 3

If the problem is not corrected or persists, contact GCH. For GCH contact

information, refer to Getting More Information or Help on page 1-8.

Table 6-2 Service Action Codes (Continued)

Reported

SAC

Perform these actions

1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 323 324

Pas de commentaire

Quantum Scalar 10K Instructions d'exploitation Page 300