Quantum P2000 Guide de l'utilisateur Page 116

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 146
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 115
Appendix C Automatic Drive Cleaning
Selection of Cleaning Mode
96 ATL P2000 Series Automated Tape Library Users Guide
Tracking and selecting cleaning cartridges
Moving a cleaning cartridge to the drive
Determining when a cleaning cartridge has used all 20 of its
available cleaning cycles
Moving used up cartridges to the load port
Selection of Cleaning Mode
3
The cleaning mode is selectable from:
The diagnostic software
The touch screen GUI
A Mode Select command
The default cleaning mode is host-initiated. A Mode Select
command permanently changes the cleaning mode in the librarys
NVRAM, and is retained if the library power is cycled.
Diagnostic
Software
3
To change automatic cleaning mode from the diagnostic software
select
Config
:
Enable clean tape
- turns automatic cleaning mode on
Disable clean tape
- turns automatic cleaning mode off
Touch Screen GUI
3
To change automatic cleaning mode from the touch screen GUI,
select
Configuration/AutoClean
:
Enable
- turns automatic cleaning mode on
Disable
- turns automatic cleaning mode off
Vue de la page 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 145 146

Commentaires sur ces manuels

Pas de commentaire