Quantum DAT 240 Loader Manuel d'utilisateur télécharger pdf (Page 28)

Scorpion 240 Product Manual

Installing an external Scorpion 240

The external Scorpion 240 is a compact external SCSI device that connects to the

host computer as a turnkey subsystem. Installing the external drive involves three

simple steps:

1. Configuring the drive

2. Connecting the SCSI interface cable

3. Connecting the power cord

Configuring the external Scorpion 240

The following is the default configuration for the external Scorpion 240:

Drive configuration Default setting

SCSI ID 6

Media Recognition System (MRS) checking Enabled.

Parity checking Enabled.

Data compression Enabled.

Power-on self-test diagnostics Enabled.

Host operating system Windows 95/98/NT/2000

Termination power Supplied to the SCSI bus.

Note: Some of these configuration settings can be changed using the SCSI Mode

Select command. SCSI command information for these drives is provided in

the Scorpion 240 SCSI manual.

Setting the SCSI ID

Make sure that the drive is turned off; then set the SCSI ID for the drive using the push-

button switch on the back of the external drive. Figure 9 shows this switch, as well as the

two SCSI interface connectors, on/off switch, and the power-cord connector.

Note: The drive must be restarted for any change in SCSI ID to take effect.

–

68-pin wide SCSI

connectors

SCSI ID selector

On/Off switch

AC Power connector

Figure 9. Rear panel of external Scorpion 240

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Pas de commentaire

Quantum DAT 240 Loader Manuel d'utilisateur Page 28