Quantum DAT 240 Loader Manuel d'utilisateur télécharger pdf (Page 31)

Drive Operation and Maintenance

Note. If your computer does not recognize the autoloader, you may need to load

the appropriate autoloader module for your software package. See your

software installation manual for additional information.

Using cartridges and magazines

Applying labels

When applying labels to a cartridge, observe the following precautions to prevent the

cartridge from getting stuck in the autoloader:

•

Apply labels firmly, only in recessed label areas.

•

Do not let labels extend beyond label areas or fold over the edge of a cartridge.

•

Do not apply labels over other labels.

Caution Do not place any labels on the autoloader magazine, since this may

cause the tape mechanism to jam.

Loading cartridges in a magazine

Use only approved DDS cartridges in the Scorpion 240. Approved Seagate

cartridges are listed on page 10. To load cartridges into the magazine, follow these

steps:

1. Make sure that the cartridges and magazine are write protected or write

enabled, as necessary. See page 33 for details.

2. Hold the magazine so that the slot numbers on the side of the magazine are

right-side-up.

3. Insert the cartridge into the magazine with the door facing toward the magazine

slot, as shown in Figure 12.

Cartridge door

Figure 12. Inserting a cartridge into the autoloader magazine

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

Pas de commentaire

Quantum DAT 240 Loader Manuel d'utilisateur Page 31