Quantum DLT-V4 Manuel d'utilisateur télécharger pdf (Page 24)

Chapter 2 Installing the Internal SCSI Tape Drive

Terminating the Internal SCSI Tape Drive

DLT-V4 Product Manual 8

Terminating the Internal SCSI Tape Drive 2

If the tape drive is the only SCSI device attached to the selected server

other than the SCSI host adapter, or if it is the last physical device on the

SCSI bus (at the end of the SCSI chain), you must terminate it. If another

SCSI device is the last device on the SCSI bus, confirm that it is properly

terminated and do not terminate the tape drive.

To terminate the tape drive, install an active LVD/SE cable-end or inline

terminator on the SCSI cable you intend to use with the tape drive, as

shown in figure 2

. You can use a cable-end terminator or an inline

terminator, whichever is most convenient. See the terminator’s

instructions for more information.

Note: Regardless of which device terminates the SCSI bus, that

device must have power applied and be powered on for

proper termination to occur.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 96 97

Pas de commentaire

Quantum DLT-V4 Manuel d'utilisateur Page 24