Quantum DLT-V4 Manuel d'utilisateur télécharger pdf (Page 41)

Chapter 4 Installing the Internal SATA-to-USB Tape Drive

Unpacking the Internal SATA-to-USB Tape Drive

DLT-V4 Product Manual 25

Unpacking the Internal SATA-to-USB Tape Drive 4

Before you do anything else, unpack and inspect the tape drive for

shipping damage. If you notice any damage, report it both to the sales

representative and to the shipping company immediately.

If there is no damage to the tape drive, select a server or workstation to

host the tape drive, then move on to the following installation steps.

Installing the Internal SATA-to-USB Tape Drive 4

To install the tape drive, follow these steps:

1 Shut down the operating system and power off the server or

workstation.

2 Power off all peripheral devices, such as printers and other connected

devices.

Note: Save the packing materials in case you need to move or ship

the tape drive in the future. You must ship the tape drive in

the original (or equivalent) packing materials or you will

invalidate the warranty.

Caution: Do not go to step 3 until you have completed steps 1

and 2. Failure to follow these instructions may result

in damage to the tape drive or other devices.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 96 97

Pas de commentaire

Quantum DLT-V4 Manuel d'utilisateur Page 41