Quantum P1000 Guide de l'utilisateur télécharger pdf (Page 37)

Chapter 2 Installing the P1000 Library

Unpacking the P1000

ATL P1000 Series User’s Guide 21

Installing the Slide

Assembly in the Rack

If you are installing a rack-mount library, install the slide assembly in

the rack before proceeding to the next section, “Removing the Library

from the Pallet.” See appendix B for slide assembly installation

instructions.

Removing the Library

from the Pallet

This section provides separate procedures for the stand-alone and

rack-mount libraries:

•

To remove a stand-alone library from the pallet, see the following

section, “Removing a Stand-alone Library from the Pallet.”

•

To remove a rack-mount library from the pallet, see “Removing a

Rack-mount Library from the Pallet” on page 23.

Warning:

Two people should perform steps that involve lifting or

guiding the library. Use safe practices when lifting or

guiding the library and handling the slide assembly or the

ramp.

Removing a Stand-alone Library from the Pallet

To remove a stand-alone library from the pallet:

Procedure

Remove the plastic bag enclosing the P1000:

Cut along the front seam of the plastic bag.

Continue to cut all the way to the back of the library.

Fold the bag out of the way.

Remove the foam supports from between the library and the pallet

(see figure 15).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 131 132

Pas de commentaire

Quantum P1000 Guide de l'utilisateur Page 37