Quantum P1000 Guide de l'utilisateur Page 68
- Page / 132
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 3 Basic Operations
Performing Manual Operations
52 ATL P1000 Series User’s Guide
Placing the Library
Off-line
3
To place the library off-line:
Note:
You must have Operator level access privileges or higher to perform
this procedure (see “Changing the GUI Security Level” on page 49).
Procedure
1
With the library turned on and the GUI indicating “System
On-line,” press the Standby button on the GUI.
2
Verify that the GUI displays “System Off-line.”
Turning Off the Library
3
To turn off the library:
Procedure
1
Place the library off-line (see the previous section, “Placing the
Library Off-line”).
The library completes the current command and then stops.
2
Verify that the GUI displays “System Off-line.”
3
Verify that the gripper is empty by checking the Overview screen.
4
If there is a tape cartridge in the gripper, execute a Move command
to place the cartridge in an empty bin or drive (see “Moving a
Cartridge” on page 64).
5
At the front panel, set the power switch off.
Caution:
Always leave the library power off for at least 15 seconds
before turning it on again.
Inserting Tape
Cartridges
3
This section explains how to insert tape cartridges.
Note:
You must have Import Only level access privileges or higher to
perform this procedure (see “Changing the GUI Security Level” on
page 49).
Caution:
Do not use CompacTape I™, CompacTape II™, or
CompacTape IIIXT™ tape cartridges in this library.
- User’s Guide 1
- Audience 13
- Document 13
- Organization 13
- Table 1 Related 14
- Documentation 14
- Library Description 17
- Chapter 1 Library Description 18
- Figure 2 P1000 Front 18
- View, Rack-mount Library 18
- Configuration Options 19
- Figure 3 P1000 Library 20
- Back View 20
- Library Elements 21
- Figure 4 Library Elements 22
- Robotics Operation 23
- Front Panel 24
- PRODUCTS 25
- Load Port 26
- Load and Bulk Packs 26
- Back Panel 27
- Tape Drives 28
- Installing the P1000 Library 29
- Site Requirements 30
- Floor Clearance 31
- Floor Strength and 31
- Inclination 31
- Overhead Clearance 31
- Power and Grounding 31
- Figure 11 AC Power 32
- Receptacle 32
- Unpacking the P1000 33
- Uncrating the Library 34
- Checking the 36
- Contents 36
- Preparing and Inserting Tape 46
- Cartridges 46
- Orange tab 48
- Write-protect switch 48
- Placing Tape 50
- Cartridges in the Load 50
- Connecting Host Computers 51
- Figure 26 Single-Host 52
- SCSI Configuration 52
- Figure 28 Five-Host SCSI 54
- Configuration 54
- Turning On the Library 55
- Table 3 Sample Library 56
- Basic Operations 57
- Chapter 3 Basic Operations 59
- Using the GUI 59
- Table 4 Vertical Bar 59
- Buttons and Indicators 59
- Table 6 GUI Screens 61
- Figure 31 GUI Screens 61
- Obtaining Library Status 62
- Activity 63
- Load Pack 64
- Tapes Screen 64
- Performing Manual Operations 67
- Opening the Library 70
- Manually Ejecting a 71
- Cartridge 71
- Operator Commands 73
- Configure 76
- Configuring Library Options 78
- Performing an Inventory 82
- Calibrating the Library 83
- Chapter 4 Operator Commands 84
- Exercising the Library 85
- Unloading the Load Port 87
- Service Commands 89
- Performing a Service 96
- Calibration 96
- Chapter 5 Service Commands 97
- Reenter the new password 100
- Press the Execute button 100
- Troubleshooting 101
- Start-up Problems 102
- GUI Problems 103
- Robotics Problems 104
- Operating Problems 106
- Tape Drive Problems 108
- Specifications 109
- Appendix A Specifications 110
- Table 16 Environmental 110
- Rack Current Rating 114
- Consideration 114
- Grounding 114
- Temperature 114
- Procedure 115
- Procedure (continued) 116
- Figure 55 Installing the 118
- Slide Assembly in the Rack 118
- Adjusting the Slide Assembly 119
- Adjusting the Slide 121
- Assembly Tray on the 121
- Slide Rails 121
- Glossary 125
Produits connexes et manuels pour Chargeurs automatiques de bandes et bibliothèques Quantum P1000
Chargeurs automatiques de bandes et bibliothèques Quantum Scalar 100 Guide de l'utilisateur
(130 pages)
(130 pages)
Chargeurs automatiques de bandes et bibliothèques Quantum SDLT 320 Guide de l'utilisateur
(102 pages)
(102 pages)
Chargeurs automatiques de bandes et bibliothèques Quantum Scalar i2000 Guide de l'utilisateur
(77 pages)
(77 pages)
Chargeurs automatiques de bandes et bibliothèques Quantum Scalar i40 Guide de l'utilisateur
(340 pages)
(340 pages)
Chargeurs automatiques de bandes et bibliothèques Quantum Scalar 50 LTO-3HH Guide de l'utilisateur
(290 pages)
(290 pages)
Chargeurs automatiques de bandes et bibliothèques Quantum Scalar i80 Guide de l'utilisateur
(18 pages)
(18 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.015 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels