Quantum P1000 Guide de l'utilisateur télécharger pdf (Page 49)

Chapter 2 Installing the P1000 Library

Preparing and Inserting Tape Cartridges

ATL P1000 Series User’s Guide 33

Procedure (continued)

Remove the load and bulk packs from the library (see figure 20 on

page 28):

Grip the load pack handles and squeeze them together.

This releases the latches securing the load pack.

Still holding the load pack handles, pull the load pack forward

and out of the library.

Repeat steps 2a and 2b to remove the bulk pack.

Set both packs aside.

Reaching in through the front doors of the library, insert a tape

cartridge into each of the nine storage bins above the tape drives.

(See figure 25 for the correct tape cartridge orientation.)

Each cartridge should slide into place with very little force. If a

cartridge does not slide into place easily, check the cartridge for

correct orientation and structural integrity.

Figure 25 Correct Tape

Cartridge Orientation

Insert a cartridge into each of the five storage bins above and

below the load port at the front of the library.

This requires you to reach into the library through the front doors

and then back toward the front. There are four bins above the load

port and one bin below.

Verify that each cartridge is properly seated in the bin (see

figure 25 for correct cartridge orientation).

Insertion arrow

Bar code label

Write-protect switch

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 131 132

Pas de commentaire

Quantum P1000 Guide de l'utilisateur Page 49