Quantum P1000 Guide de l'utilisateur télécharger pdf (Page 50)

Chapter 2 Installing the P1000 Library

Preparing and Inserting Tape Cartridges

34 ATL P1000 Series User’s Guide

Placing Tape

Cartridges in the Load

and Bulk Packs

To place cartridges in the load and bulk packs:

Note:

This procedure assumes that you have already removed the

load and bulk packs. If not, remove the load and bulk packs,

referring to steps 2a through 2c on page 33.

Procedure

Load eight cartridges into each pack.

As you slide each cartridge into a bin, there should be initial

resistance from the retention mechanism before the cartridge snaps

into place. If a cartridge does not snap into place, check for correct

orientation and structural integrity.

Verify that each cartridge is properly oriented and seated in the bin

(see figure 25 on page 33 for proper cartridge orientation).

Caution:

Handle the load and bulk packs with care. The

retention mechanism that secures the cartridges may be

compromised by rough handling, causing the cartridges

to fall out.

Reinstall the load and bulk packs:

Insert a pack into the library, cartridge-side first.

Line up the pack with the plastic guides on the top and bottom

of the library frame.

Slide the pack onto the guides until it snaps into place.

Repeat steps 3a through 3c for the other pack.

Close and lock the library doors.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 131 132

Pas de commentaire

Quantum P1000 Guide de l'utilisateur Page 50