Quantum Scalar i500 Guide de l'utilisateur télécharger pdf (Page 305)

100

101

Scalar i500 User’s Guide 286

Chapter 12

12Installing, Removing, and

Replacing

This chapter describes how to add, remove, and replace hardware within

your library. Adding, removing, or replacing library components may

require you to power off the entire library. There are a few components,

however, that you can service without powering off the library, such as

replacing tape drives. Instead, you may only need to take a specific

partition offline, or you may not need to impact the status of the library at

all.

Warning: All libraries taller than 14U must be installed in a rack

having a main protective earthing (grounding) terminal,

and power must be supplied via an industrial plug and

socket-outlet and/or an appliance coupler complying with

IEC 60309 (or an equivalent national standard) and having

a protective earth (ground) conductor with a cross

sectional area of at least 1.5 mm

(14 AWG).

To ensure proper airflow and access space, allow 60 cm (24

inches) in the front and back of the library.

Warning: Under no circumstances should a rack be moved while

loaded with one or more modules.

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 569 570

Commentaires sur ces manuels

Pas de commentaire

Quantum Scalar i500 Guide de l'utilisateur Page 305

Commentaires sur ces manuels

Produits connexes et manuels pour Non Quantum Scalar i500