Quantum Scalar i500 Guide de l'utilisateur Page 399

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 570
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 398
Chapter 12 Installing, Removing, and Replacing
Replacing the Control Module
Scalar i500 User’s Guide 380
6 Open the module’s access door and raise the guide pin by pulling it
up and turning it slightly as if it were a screw. Otherwise, the guide
pin may scratch the front doors of the module beneath it.
7 Slide the entire module toward you and lift it off of the module below
it.
Replacing the Control
Module 12
1 If not already removed, remove the tape drives and power supplies
from the control module you are replacing.
2 Using the Phillips #2 screwdriver (for the top cover plate) and the
T10 TORX screwdriver (for the bottom cover plate), remove the new
control module plates from the top and bottom of the module, as
necessary.
1 Guide pin
2 Thumbscrew
Vue de la page 398
1 2 ... 394 395 396 397 398 399 400 401 402 403 404 ... 569 570

Commentaires sur ces manuels

Pas de commentaire