Quantum Scalar i500 Guide de l'utilisateur télécharger pdf (Page 366)

100

101

Chapter 12 Installing, Removing, and Replacing

Adding Expansion Modules to an Existing Library

Scalar i500 User’s Guide 347

Installing the New 9U

Expansion Module 12

Install the new 9U expansion module as follows:

1 Prepare the rack to hold modules, if you want to install your library

in a rack. See Installing the Library in a Rack

on page 417 for

instructions on installing a rackmount kit.

2 Remove and replace the cover plates, if appropriate.

a If you plan to stack the control module at the top of the library,

and if an expansion module will be located below it, remove the

control module’s bottom cover plate and the expansion module’s

top plate.

b If you plan to stack the control module between expansion

modules, remove both the top and bottom plates of the control

module. Also remove the top plate of the expansion module,

located below the control module, and the bottom plate of the

expansion module, located above the control module.

c If you plan to stack the control module at the bottom of the

library, and if an expansion module will be located above it,

remove the control module’s top plate and the expansion

module’s bottom plate.

Caution: Before removing the control module’s bottom cover plate,

the robot assembly must be parked as described in

Preparing to Install an Additional Expansion Module

above.

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 569 570

Commentaires sur ces manuels

Pas de commentaire

Quantum Scalar i500 Guide de l'utilisateur Page 366

Commentaires sur ces manuels

Produits connexes et manuels pour Non Quantum Scalar i500