Quantum Scalar i500 Guide de l'utilisateur télécharger pdf (Page 371)

100

101

Chapter 12 Installing, Removing, and Replacing

Adding Expansion Modules to an Existing Library

Scalar i500 User’s Guide 352

a From the front of the library, open the I/E station and access

doors of the expansion module.

b Squeeze the handle of the Y-rail release mechanism, lift it out of

its locked position, and slide it downward as far as it will go.

c From the back of the library, find the rear Y-rail release

mechanism, which is located in the interior of the right side of the

module. Squeeze the handle of the Y-rail release mechanism, lift

it out of its locked position, and slide it downward as far as it will

go.

Doing this aligns the Y-rails with the Y-rails of the module

beneath it.

Caution: Check to make sure that there is no gap between the top

and bottom Y-rails on both the front and back of the

library. If a gap exists, the library cannot mechanically

initialize.

1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 569 570

Commentaires sur ces manuels

Pas de commentaire

Quantum Scalar i500 Guide de l'utilisateur Page 371

Commentaires sur ces manuels

Produits connexes et manuels pour Non Quantum Scalar i500