Quantum Scalar i2000 Guide de l'utilisateur Page 132

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 544
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 131
Chapter 4 Configuring Your Library
Working With Partitions
Scalar i6000 User’s Guide 119
The method you should choose depends on the circumstance and the level
of control you want in allocating resources to the partition. In Automatic
mode, the library assigns available system resources to create the number
of partitions you specify. Automatic mode is not available if a partition
already exists. Manual mode enables you to pick specific drives, storage
magazines, and magazines within an I/E station to assign to a partition.
Make sure that you have adequately planned for
the number of partitions that you want to
configure.
Creating Partitions With the Setup Wizard 4
If you are performing an initial configuration of your library, you can use
the Setup Wizard to automatically create partitions using the available
system resources. Using the Setup Wizard is part of the normal
installation procedure for a library without I/O blades.
You should run the Setup Wizard only when you
initially configure the library.
At all other times, create partitions by using the
Partitions command from the Setup menu.
Vue de la page 131
1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 543 544

Commentaires sur ces manuels

Pas de commentaire