Quantum Scalar i2000 Guide de l'utilisateur télécharger pdf (Page 450)

100

101

Chapter 6 Maintaining Your Library

Maintenance Actions

Scalar i6000 User’s Guide 437

Blade Inventory 6

This inventory list provides the following information about each Fibre

Channel I/O blade:

• Location of each blade

• Serial number of the blades

Test Results

The results of all subtests appear on the Verification Tests dialog box after

each individual test is completed. See table

34 for an explanation of test

results.

Table 34 Test Results

Test Results Explanation

PASSED Completed the test without reported errors.

MARGINAL Completed the test, but the system had to retry or had to skip part of the test. A

MARGINAL

result is considered PASSED, but the log should be checked to see if

the marginality can be corrected.

FAILED An error has been found and needs to be corrected. A fatal error, or an error that

causes a par

t of the system to become disabled, will halt the test.

INCOMPLETE This portion of a test was incomplete due to an

interruption or a portion of the test

was run (for example, no scratch tape was used so must only use existing tapes).

An incomplete will occur when the door is opened, an abort command is issued,

or when the Robotics Enable button is pressed.

SKIPPED This portion of the test was skipped. The caus

e is that either a scratch tape was not

present or the library was not configured for the test.

WARNING A warning is additional information about the test tha

t the user should know. For

example, if a calibration failed, but the stored offsets are analyzed, a warning

should be posted that states that the offset check might not be accurate.

STOPPED The test was interrupted. The log will show the

result to provide a record of test

interruption.

1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 543 544

Commentaires sur ces manuels

Pas de commentaire

Quantum Scalar i2000 Guide de l'utilisateur Page 450

Commentaires sur ces manuels