Quantum Scalar i2000 Guide de l'utilisateur Page 241

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 544
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 240
Chapter 4 Configuring Your Library
Using LDAP
Scalar i6000 User’s Guide 228
SNMP — To prevent all SNMP traffic across the MCB Ethernet
port, select Disable. To allow SNMP Get operations, select
Enable.
If SNMP traffic is allowed, then SN
MP v3 is always available. If
you want to permit less secure SNMP access, select Enable
SNMP v1 and v2. If you decide you do not want to use SNMP v1
and v2, clear the Enable SNMP v1 and v2 check box.
The library ignores all remotely issued
SNMP SET operations under
any circumstance, which means that external applications cannot
register themselves to receive SNMP traps from the library. However,
the Trap Registration dialog box (Setup Trap Registration)
enables you to perform this registration yourself by entering the
necessary IP and port information. For more information about the
Trap Registration dialog box, see
Registering SNMP Traps on
page 219.
3 If you want to appl
y the changes, but you do not want to close the
dialog box, click Apply. Otherwise, click OK to apply the changes
and close the dialog box.
Using LDAP
Lightweight Directory Access Protocol (LDAP) is the industry standard
Internet protocol that provides centralized user account management.
This library supports the Microsoft
®
Active Directory
®
LDAP server and
user account information in the schema defined by RFC 2307. User
password schemes must be encrypted using UNIX® crypt.
The Scalar i6.5 release provided enhancements to
the Lightweight Directory Access Protocol (LDAP)
features.
For maximum ease of use of this feature, Quantum
strongly recommends that you are running version
i6.5 or greater.
Vue de la page 240
1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 543 544

Commentaires sur ces manuels

Pas de commentaire